|
Applicable standard |
USB Ver 2.0 |
| Speed |
High-speed (480Mbps), Full-speed (12Mbps), Low-speed (1.5Mbps)
The speed is recognizer/switched
automatically. |
| Data logging system |
Recording in blocks of a byte to PC's hard
disk |
| Record capacity |
Max. 2 GB (recorded to PC's hard disk)
Main unit buffer size 512 MB
|
| PC interface |
USB (Ver. 2.0)
standard port (Port B) |
| Input/output terminal |
USB port (A connector and B connector each 1) |
| Indication ¡]LED¡^ |
USB BUS |
HI :
Lights up when connected to a high-speed devices.
FULL : Lights up when connected to a full-speed
devices.
LOW : Lights up when connected to a low-speed
devices.
RESET : Lights up at bus reset.
SUSPEND : Lights up in die state. |
| LOGGING |
FULL:
Lights up when the build-in buffer memory is
full. EMPTY: Lights up when the build-in
buffer memory is empty. |
|
Other |
POWER:
Lights up when the power is on.
READY: Ligths up when an operation is ready.
DATA STREAM: Lights up when data is flowing. |
| Comment |
Up to 1024 bytes can be
entered for each log file. |
|
Display packet |
OUT, IN, SOF, SETUP, DATA0,
DATA1, DATA2, MDATA, ACK, NAK, STALL, NYET, PRE, ERR, PING, SPLIT |
|
Display filter |
SOF, PING-NAK, NAK, IN-NAK,
OUT-NAK/SETUP-NAK,
address and end point |
| Search |
SOF, CRC Error, PID Error,
Setup-Token, IN-Token, OUT-Token, PING-Token, ACK, NAK, STALL, NYET,
specified address,
specified endpoint, no communications at specified time, and over |
|
Mark & Jump |
Up to 99
marks can be set for each log file. Deletion of marks, jumping to marks,
listing and editing marks. |
|
Power Supply |
100V to 240V AC, 50/60 Hz, Max. 10 VA |
|
Size & weight |
Approx.
145 X 45 X 192.5 (mm), approx. 1 kg |
|
Accessories |
SB-2020
Software CD-ROM (1), Power cord (1), USB cable (2), instruction manual
(1) |
|
Environment |
Operating temperature +5 to +40¢J
Operating humidity 80% RH or less (noncondensing) Storage temperature 0¢J
to +55¢J |
|
